Installation Instructions
Unpack all components carefully.
Set up the steel frame in the desired place on an even, solid surface. Please keep in
mind that some water may splash over the rim of a bowl, do not set up the cascade
fountain on a surface which may be damaged by water.
Connect the hose from the top jug to the vent of the pump and place the pump on the
floor of the reservoir bowl. Place all remaining bowls onto the frame.
Fill reservoir with clean water and ensure pump is fully submerged.
Connect the pump cable to the socket of the control housing on the rear side of the
solar panel; the solar fountain is now ready to use.
Operating Instructions
Turn on the pump: short press the ON/OFF position to turn on the pump, the pump will run
certain hours (refer to battery status) and turn to solar mode automatically. The pump will
operate automatically next day in direct sunlight.
Charge the battery: press and hold on 3 seconds to turn OFF the pump and charge the full
solar energy to battery during day time, turn on the pump when you need it (on demand).
Battery status:
Green: battery is full charged. Pump will run around 6-8 hours.
Orange: battery is half charged. Pump will run around 2-6 hours.
Red: battery needs charges. Pump will run less than 1 hour.
(Note: In order to protect battery, don’t manually turn on the pump frequently)
Note: The indicator light is solid when charging battery.
Trouble Shooting Tips
1) Pump does not operate even thought the solar module is in full sunlight.
No connection to the solar module - check connection to the solar module.
Impeller is blocked - To clean the pump, remove the front plate and the impeller.
Use a small brush or steam of water to remove any debris.
2) Pump does operate but there is no water running through the fountain head
check for the build up of sediment or scale in the tubes or the filter- clean the tubes and the filter.
